Started putting on the indicator, brake and headlights and fastening them to the body. Checked to see if the electronics were working – the red light came on – hooray! Spent a good amount of time sending down the fiberglass joins and tried to fill / sand the low areas with very quick drying rage gold body filler.
The hood scoop was a bit intimidating to cut out, but followed the instructions, measured the center, drilled the rivet holes, and used the jigsaw to cut out the panel from the double layer hood material - looked cool with the cleckos holding it on!
The hood scoop was a bit intimidating to cut out, but followed the instructions, measured the center, drilled the rivet holes, and used the jigsaw to cut out the panel from the double layer hood material - looked cool with the cleckos holding it on!
No comments:
Post a Comment